XRAY: COMPOSITE BALL DIFFERENTIAL GEAR 53T
Molded ball-differential 53T bevel gear made from tough composite material.
Molded ball-differential 53T bevel gear made from tough composite material.
Diff rings for #365000 Ball Adjustable Differential for XB4 cars. ID x OD x thickness = 17mm x 24.5mm x 1.0mm. Set of 2.
REAR linear springs have been specifically designed to complement the big bore shocks. Spring rate is constant during the entire spring compression...
View full detailsSteering block graphite extension, works on either left or right side. Allows for easy Ackermann position adjustment for fine-tuning on all surface...
View full detailsAnti-roll bar set 1.0mm made from special spring steel material. Stabilizes the front & rear of the car. Roll bars are easily mounted to the di...
View full detailsThe springs have been specifically designed to complement the big bore shocks. The spring rate is constant during the entire spring compression.The...
View full detailsOptional spur gear for 3-Pad Slipper Clutch. Precision-molded slipper clutch spur gear 87T 48P is made from XRAY's exclusive secret blend of compos...
View full detailsPrecision-molded spur gear 84T is made from XRAY's exclusive secret blend of composite material, allowing the gear to run yet be robust enough to h...
View full detailsPrecision-molded spur gear 81T is made from XRAY's exclusive secret blend of composite material, allowing the gear to run yet be robust enough to h...
View full detailsUltimate assortment of set-up shims. You can use the shims for easy and accurate adjustment of:• front and rear roll center• front bump steer• fron...
View full detailsFull set of 24 high-speed, blue-sealed ball-bearings are used throughout the drivetrain to ensure maximum efficiency. All of the bearings are degre...
View full detailsStylish, effective rear center fin was developed and long term tested to maximize the rear wing air flow efficiency. Center fin is mounted on #3235...
View full detailsMolded composite steering ball-joint for T2 family of cars and T3. Fits 5mm pivot ball or ball stud. Set of 4. The closed ball joint prevents du...
View full detailsThreaded 4.9mm ball end with 6mm thread length for connection to molded ball joints. Set of 2.
Silicone O-ring fits for 3mm shaft. 2.1mm thick. Set of 10.
FRONT linear springs have been specifically designed to complement the big-bore shocks. Spring rate is constant during the entire spring compressio...
View full detailsThe springs have been specifically designed to complement the big bore shocks. The spring rate is constant during the entire spring compression.The...
View full detailsMolded composite 4.9mm ball joints for anti-roll bar links, same as included in anti-roll bar sets #302401 (front) and #303401 (rear). Set of 4.
XB2 Gamma 2D body is designed especially for low traction tracks. The profile of the body improves the stability and increases downforce towards th...
View full detailsSpecial screw for ball-differential external adjustment, made from world-renowned HUDY Spring Steel™. Suitable for #325002 Adjustable Ball Differen...
View full detailsAlu steering plate for rearward linkage mounting allows mounting the steering linkages more rearwards which makes the steering more precise and mak...
View full detailsXRAY precision-molded offset spur gear 72 tooth, 48 pitch for Slipper Eliminator. This spur gear has been strategically lightened to reduce rotatin...
View full details