Xray X4 Parts

XRAY precision molded spur gear 84 tooth, 48 pitch. This spur gear has been strategically lightened to reduce rotating mass. Product released: 3rd...

XRAY precision molded spur gear 84 tooth, 48 pitch. This spur gear has been made from special hard composite material, strategically lightened to ...

Molded composite servo saver set - extra stiff. Consists of 4 springs to make the servo saver strong enough to prevent extreme steering deflection ...

Low-friction 3.5mm drive pin clips for protecting and cushioning drive shaft pin in diff outdrives. Made from all-new, extra-strong composite mixt...

Optional specially-modified high-performance Kevlar®-reinforced 351mm-long, 3mm-wide drive belt.This belt is very thin and elastic as possible for...

Molded composite 4.9mm ball joints, open on both sides, for connection to 4.9mm ball. Set of eight. Fits XRAY T2, T3, T4, RX8, XB8, NT1, X1 and GTX8

Threaded 4.9mm ball end with 8mm thread length for connection to molded ball joints. Set of 2.

This is a pack of four replacement XRAY Differential Gaskets, and is intended for use with the XRAY T3 family of 1/10 touring cars equipped with th...

XRAY precision-molded offset spur gear 72T 48P, strategically lightened to reduce rotating mass.

New X4 Alu Hub - Swiss 7075 T6• Alu hubs for X4• Ultra-strong• Long life• Reduces flex• Improves consistency• Full height adjustability• Mainly for...

The unique CFF suspension arms are an elegant engineering achievement that look great and perform even better on the track. Using XRAY's own newly ...

Precision-molded Graphite composite hub for X4 features new suspension geometry for improved steering and traction. The hubs contain updated drive ...

Polished chrome pin. Dia. x length = 2mm x 9.8mm. Set of 10 pieces.

The unique CFF suspension arms are an elegant engineering achievement that look great and perform even better on the track. Using XRAY's own newly ...

Alu shims 3x6mm size, 1mm thick, set of 10. Available in Black, Orange or Silver

Molded composite steering ball-joint for T2 family of cars and T3. Fits 5mm pivot ball or ball stud. Set of 4.  The closed ball joint prevents du...

Silicone O-ring fits over 24mm shaft. 0.7mm thick. Set of 10 pieces.

Threaded 4.9mm ball end with 5mm thread length for connection to molded ball joints. Set of 2.

Rubber O-ring fits over 5mm shaft. 1mm thick. Set of 10 pieces.

Threaded 4.9mm ball end with 10mm thread length for connection to molded ball joints. Set of 2.

Molded composite 4.9mm ball joints, special design for X4 front and rear upper arms. For connection to 4.9mm ball. The front composite ball joints ...