XRAY: DIFF GASKET (4)
This is a pack of four replacement XRAY Differential Gaskets, and is intended for use with the XRAY T3 family of 1/10 touring cars equipped with th...
View full detailsThis is a pack of four replacement XRAY Differential Gaskets, and is intended for use with the XRAY T3 family of 1/10 touring cars equipped with th...
View full detailsSuspension pivot pins, hardened for very high durability and long life, polished for smooth operation. Used on inboard pivot point of XB4 suspensio...
View full detailsThreaded 4.9mm ball end with 5mm thread length for connection to molded ball joints. Set of 2.
Rubber O-ring fits over 5mm shaft. 1mm thick. Set of 10 pieces.
Threaded 4.9mm ball end with 10mm thread length for connection to molded ball joints. Set of 2.
Molded composite C-hub for steering block. Caster pre-set at 6°. The roll center position can be easily and quickly adjusted by inserting different...
View full detailsXRAY precision molded offset spur gear 81 tooth, 48 pitch. This spur gear has been strategically lightened to reduce rotating mass.
Molded composite steering ball-joint for XRAY XII Link. Fits 4.2mm pivot ball or ball stud. Set of 4.
Silicone O-ring fits for 3mm shaft. 2.1mm thick. Set of 10.
Front lower inner pivot pins. Hardened for very high durability and long lifespan. Set of 2.
HARD molded composite LEFT C-hub, suitable for high- and very-high-traction conditions. Generates more steering, more aggressive handling of the ca...
View full detailsHARD molded composite RIGHT C-hub, suitable for high- and very-high-traction conditions. Generates more steering, more aggressive handling. Use wit...
View full detailsEccentric bushings for adjusting suspension settings, made from tough composite. Fits alu and composite multi-adjustable rear uprights. Two sets of...
View full detailsFlat washer. ID x OD x thickness = 3.5mm x 10mm x 0.2mm. Set of 10 pieces.
M2.5x6 flat-head machine screw, hex drive. Set of 10 pieces.
Set of composite shims for mounting servos to mounting posts. Includes: 3x6x1mm (qty 4), 3x6x2mm (qty 4), 3x6x3mm (qty 4).
Molded composite C-hub for steering block. Caster pre-set at 6°. The roll center position can be easily and quickly adjusted by inserting different...
View full detailsHigh-speed ball-bearings manufactured specially for XRAY. ID x OD x thickness (mm) = 10x15x4. Top-quality professional ball-bearings for a super-fr...
View full detailsHARD molded composite steering block is tiny yet tough, includes graphite Ackermann extension for variable Ackermann positions. Generates less on-p...
View full detailsPolished chrome pin for CVD drive shaft, 2 x 10mm. Specially hand-ground for maximum precision. To help prevent of loosening of the setscrew from t...
View full detailsM3x4 button-head stainless steel machine screw, hex drive. Set of 10 pieces.
New high-speed ball-bearings manufactured specially for XRAY. ID x OD x thickness (mm) = 5x9x3. Set of 2 pieces.Top-quality professional ball-beari...
View full detailsHARD molded composite C-hub for LEFT steering block. Made from super-tough, high-tech composite material. Caster pre-set at 9°. For use with matchi...
View full details